Thanks guys
Joe, it's the same basic design as this one how-to with a few minor alterations:
http://www.dendroboard.com/forum/par...step-step.html
1. I don't use a euro vent in the front under the door (though you definitely could with this setup)
2. Instead of the sliding door with the plastic rail, I use magnets and an aluminum ledge. I build a 4 piece "frame" on the front (the size of each piece changes depending on what size tank I'm building), then cut and place the aluminum ledge on the bottom piece in between the left and right pieces. Then I silicone a magnet on the inside of the viv at the top, and silicone another magnet on the outside of the door so they line up. It should go magnet - glass - glass - magnet.
I usually cut the doors so they overlap 1-2 inches on each side and 2-4 inches at the top. That might not make any sense, but it's the best I can do to explain it.
Chris, do you have any idea what brom this might be? I picked it up the last time I was by your place and I've completely forgotten the name. I'm really hoping I can get it to color back up again
Originally Posted by VicSkimmr
Thanks guys
Reply With Quote
