Exo-terra monsoon

[DonLisk]

Well all nozzles can clog and that can be fixed by gently inserting a fine needle in the hole to clear the junk. Also using distilled water can alleviate many of those issues.

Mike, How is the timer on your Monsoon working. I can't seem to get mine to go off at any specific interval. I set for 12 hours and 15 hours later is runs, so I tried every 8 hours and now 12 hours later it still hasn't ran. hmmm.

[MikeM670]

Don,

Sorry I replied using my new phone and it never showed up. Then John emailed me and said it went to the notification email.

I have not seen any issues with timing. In fact I have changed the timing several times as well as the duration. One thing I would ask is did you select the cycle button to turn the timer feature on?

Mike

[DonLisk]

Don,

Sorry I replied using my new phone and it never showed up. Then John emailed me and said it went to the notification email.

I have not seen any issues with timing. In fact I have changed the timing several times as well as the duration. One thing I would ask is did you select the cycle button to turn the timer feature on?

Mike

I set it in the off mode, then put the timer to 12 and the duration to 16 and then press the cycle button. I get the initial spray but sometimes it runs for only 10 seconds then shuts down.
The blue light is on for cycle too.
I set it today for 24 hours at 7:30 am and for 20 seconds so we'll see if it goes off in the morning at 7:30.
I hope so.

[DonLisk]

I'm at a loss here ..... So set it up for 24 hours this morning and its now 10pm and it goes off and runs for 8 seconds.... its gotta be gremlins I tell ya.

14 or so hours after setting cycle. I'll have to call Exo-Terra.

[MikeM670]

Don,

I'm afraid your right. Give them a call and see what they say. I hope it's not a bad unit and if it is them maybe they will send you out one asap. Good customer service on such a new product will certainly impress all of us.

Mike

[bshmerlie]

Don...another member mentioned he had a leak at one of the fittings on the lid and it got part of the electronics wet and shorted his out. Check for something like that just to make sure you're not having a similar problem.

[MikeM670]

Don...another member mentioned he had a leak at one of the fittings on the lid and it got part of the electronics wet and shorted his out. Check for something like that just to make sure you're not having a similar problem.

Do you know if the leak was where the tubing connected to the connection on the outside or inside the housing. When I moved my unit the other day I disconnected the line using the quick connection feature and water spilled out of the tubing. But it went down the slope towards the fill hole.

Mike