New pacman owner!!!

[Frogman1031]

Hello and welcome to Frog Forum!!

that's a beautiful albino you picked up!

no lighting is necessary, though having a light is more aesthetically pleasing. I believe it's UV lighting that is bad for albinos but I'm not sure

as for heating, i recommend using a heat pad. Be sure to stick this heat pad on the SIDE of the tank and not the bottom. These frogs burrow to stay cool and will gst confused or burned if the mat is on the bottom.

I'm going to include the forum's pacman frog care sheet so you can get more info

congrats on the new addition!!

http://www.frogforum.net/content.php...-Care-Breeding

[AFA]

Hello and welcome to Frog Forum!!

that's a beautiful albino you picked up!

no lighting is necessary, though having a light is more aesthetically pleasing. I believe it's UV lighting that is bad for albinos but I'm not sure

as for heating, i recommend using a heat pad. Be sure to stick this heat pad on the SIDE of the tank and not the bottom. These frogs burrow to stay cool and will gst confused or burned if the mat is on the bottom.

I'm going to include the forum's pacman frog care sheet so you can get more info

congrats on the new addition!!

http://www.frogforum.net/content.php...-Care-Breeding

Thanks much for the advice and I'll take your advice cause I've been researching and looking up info from various pages and most of em said to use a heating mat. I have another question about the heating mat. If I was to put the heating mat at the bottom of the terrarium and put a towel or a few towels over it and then layer with Evo Earth will this work?

Sent from my SM-G928T using Tapatalk

[Frogman1031]

The heating mat/pad should stick to the outside of the tank; the heat will travel through the glass. It is always preferable to place the mat on the side of the tank. This is the case with any burrowing animal, including pacman frogs. The frog will dig deeper into the substrate when it wants to cool off, so therefore the substrate MUST be cooler as it goes deeper or else it will become confused and stressed. The way i recommend is to place the heat mat on the side of the back wall of the tank