Anybody have picture of their set up?

[GrifTheGreat]

the one with the wrap. do you use a heating lamp in the middle?

Yes i do, but mine ave dimmer switches so the light never gets hot enough to make the dome hot so it doesn't .elt the plastic. Best thing to do is not set the lamp on the plastic wrap. You can buy lamp stands that can hold the lamp just above the lid.

[Dabrute]

ok ok..i used the wrap and this is how mine looks! Now should I place this temp and humidity thing at the end under my heat lamp or the cool end? King tapo is buried anyway lol i'm getting the hang up this and yes i see the humidity is low. also should i put the probe underneath the eco earth or what? oh and how are the temps looking? I have a dimmer on my fixture with a 50 watt night bulb and it's on/.

[Dabrute]

ok the humidity went up and the indoor temp so let me know am i doing this ok.

humidity now 55

indoor temp is now 83

[GrifTheGreat]

ok the humidity went up and the indoor temp so let me know am i doing this ok.

humidity now 55

indoor temp is now 83

Humidity needs to be a little higher. 60% and up to 80%. The gauges should be dead center of the back wall 1.5" to 2" above the substrate for a better average reading.

Make sure to poke holes in the plastic to allow air ventilation.

[Dabrute]

this is what i did

ok ok..i used the wrap and this is how mine looks! Now should I place this temp and humidity thing at the end under my heat lamp or the cool end? King tapo is buried anyway lol i'm getting the hang up this and yes i see the humidity is low. also should i put the probe underneath the eco earth or what? oh and how are the temps looking? I have a dimmer on my fixture with a 50 watt night bulb and it's on/.