Looking to upgrade vivarium setup in a 10 gal tank

[TechSmurf]

Howdy all. I've had two fire bellies for a few years now and while they've been happy, their tank has never really been anything special. 10 gallon tank, large water bowl, coco fiber (not husk!) substrate, moss overlay and a toad hut for a hideaway. I've been poring over the forums lately and I think it's time to upgrade my setup. My plan is to install a some plexiglass to cordon off half the tank for water, set up a ramp of large gravel, and install a sponge filter. I plan on keeping the coco fiber/moss setup for the other half and adding some pothos (I've got scads of starts around the house).

I've seen false bottoms mentioned a few times in the vivarium subforum-- would they be useful for the dry half of the tank? Additionally, would springtails or pillbugs be useful for helping keep the tank clean? I do a regular cleaning of the moss but I would love to have a setup that can self-regulate itself a bit more.

Are there any other additions to the tank I should integrate?

[TechSmurf]

A bit more research and I think I'm ready to go ahead with this. Skipping the false bottom, and I'm going to see if I can rustle up some pillbugs from the yard. Failing that, I'll order some. Some leaf litter and slightly recessed dry areas should keep them from venturing into a watery grave.

[NatureLady]

If you are going to divide the tank with glass or plexi there is no need for a false bottom. BUT you will need a way to drain the water out of the land portion. Also make sure that your pill bugs are collected from a pesticide free area so that their is no possible contamination. I have seen some pretty darn amazing 10g FBT vivs while doing research. Good luck and can't wait to see your progress.

[Pezoneden]

heres a pick of my 40/60 plant was out for feeding on land side crickets always run and hide in it and the frogs have a hard time climbing that one

[TechSmurf]

If you are going to divide the tank with glass or plexi there is no need for a false bottom. BUT you will need a way to drain the water out of the land portion. Also make sure that your pill bugs are collected from a pesticide free area so that their is no possible contamination. I have seen some pretty darn amazing 10g FBT vivs while doing research. Good luck and can't wait to see your progress.

What's an effective way to drain water from the land section? Should I invest in a pump, as well?

I don't use any pesticides in my yard, and I don't think pillbugs travel quite that far in their little lives, so I think they should be fine.

Pezoneden-- thanks for the photo!

I've been using this as a basic guide so far. Got the plexiglass installed last night and did a leak test tonight-- everything's going smoothly so far. I've got some photos of the work in progress I'll have to upload.

[NatureLady]

Just some sort of tube that runs to the bottom so that you can siphon the excess water.

[TechSmurf]

Here we go!

I have a little toad hut they've been using for a while now. I wanted to make sure there was enough room to sit that on the dry area.

Taping off the dry section.


I haven't used silicon like this before. I probably added way more than I needed, but I'd rather go overboard than have a leak later. It'll all be covered up anyway.


The water test! I left it filled up for a few hours and it's watertight. Tomorrow, I'm going to get some stones and add some foam shaping.