10 gallon vertical test build

[J Teezy]

Well slowly getting things rolling on this test build. Picked up a used 10 gallon for an aquatic store for $6.00. Filled it with water to test the seals, everything looks good.

Couple of pics. They don't really show much but it was more for a visual for myself to get some ideas

The metal jigger is a representation of the bulkhead with strainer drain i'll be putting in. The background is going to be a DIY rock wall made from styrofoam sheets bought at Menards. A 3/4 inch thick piece measuring 2 feet by 8 feet was like $1.50. Hobby lobby had pretty much the same stuff but it was a 1" thick that measured 12"x36" for $8.00, so keep that in mind if you plan to do the styrofoam route, check your local hardware stores first because hobby lobby is way over priced.





I can't really progress from here because I need to get my glass drill bit and bulkhead installed so that i can make the final cut on the length of the background and install the supports for the eggcrate false bottom.

I thought of wrapping the background partially around one of the sides but after i stuck some styrofoam in there on the side to get an idea of how it would look I come to the conclusion that I was loosing alot of space in the viv and it would look crammed, so I think for this one i'm going to just stick with a backwall design only

[thadmy]

Good start I went the styrofoam route too, I then covered it with GS and it turned out GREAT our atleast I think so for a first try haha.

Looking forward to this build.
Good luck

[DonLisk]

Remember to seal the front lower INSIDE around what use to be the top plastic. Although you are putting in a front lower glass or plexi piece, the original top is not sealed on the inside from leaking.

[J Teezy]

i think i'm going to use more styroform to make my rocks. Just found a guy in my cities fish club who is going to drill my tank for me, so as soon as he is available to do it will be getting that done so i can then set the FB in place so I can cut the background to its final length and get started.

One problem I'm having atm is finding some safe silicon to use. People are saying don't use anything that is for bathrooms, kitches, etc. Home Depot has GE Silicon I and II and DAP brand stuff but i'm not sure if its safe to use or not, the label doesn't really give much information about any stuff that's in it that could be an issue

[thadmy]

Shop GE 9.8 Oz. White Silicone at Lowes.com

[thadmy]

Most outside door and window by GE doesn't have anti-mildew in it. That is the stuff I used and I haven't had a problem

[J Teezy]

Ok, i'll probably grab a tube of that then, getting the tank drilled tomorrow morning so should be able to get cracking this weekend

[thadmy]

Yeah and I have mold growing in my tank so it must be an ok brand haha.... I figure if molds growing I'm in the clear